SETool RJ45 Resurrection cable SE E16i (W8)
Sony Ericsson models that require these cables are:
SETool V1.12 Release Notes - added altbypass support for xperia arc_s model, in other words, phones with 8255T chipset fully supported. - added resurrection support for s1 qualcomm-based phones with totally damaged security zone. resurrection procedure will be described in FAQ later, however, in short it is standard "recovery+write gdfs+unlocking" chain. 7227,8250-based phones require special uart cables ( pinout included in docs ), however it is highly recommended to use special GPG cables 8x55-based phones does not require any special cables. as side effect, imei repair possible now for s1 qualcomm-based phones. for 7227,8250-based phones need select COM as interface, options are: ( signed mode, altbypass mode, do full unlock, allow to change repair when unlocking, use testpoint (gnd type) ) for 8x50-based phones need select USB as interface, options are: ( signed mode, altbypass mode, do full unlock, allow to repair imei when unlocking ) cost of imei repair 5 credits, please take in mind, that if you repair imei, phone need to be unlocked, so add another 5 credits for unlock procedure. if you have calculated signature for some imei, then you can save 5 credits for unlocking - added few models to model list, so users don't get confused - different bugfixes Video:
Compatibility You need to be running at least version 1.12 of SETool software. Important Requirements Please Note: To use SETool software v1.12 and higher you will need the new GSM-Support SETool Unlocking Box to put your setool card in, as old metal box's cannot read the card using 1.12 onwards. Also Note: You will also need a uni pinout box to use the cables. Old metal box's are not uni pinout. The GSM-Support SETool Unlocking Box is a uni pinout box too and is needed to use these cables. Pack Contents 1 X GPG SETool Qualcomm Resurrection Cable for E16i (W8) |
